Helium

Helium
He
In situ availability:	trace
Necessity:
Atomic number:	2
Atomic mass:	4.002602
group:	18
period:	1
normal phase:	Gas
series:	Noble gases
density:	0.1786 g/L
melting point:	0.95K, -272.2°C, -458.0°F
boiling point:	4.22K, -268.93°C, -452.07°F
N/A ← N/A → N/A
H ← He → Li
F ← Ne → N/A
Atomic radius (pm):	31 pm
Bohr radius (pm):
Covalent radius (pm):	32
Van der Waals radius (pm):	140
ionic radius (pm):	-
1st ion potential (eV):	24.59
Electron Configuration
1s2
Electrons Per Shell
2
Electronegativity:
Electron Affinity:	Unstable anion
Oxidation states:	-
Magnetism:
Crystal structure:	Hexagonal or body centered cubic

Helium is a component of the solar wind, and hence is one of the volatiles found (in parts per million level) in Lunar regolith. It is a Noble gas in group 18 and is the second element in the Periodic Table of the Elements. This element has two stable isotopes: 3 and 4.

The most common isotope, Helium-4, has a nucleus of two protons and two neutrons, and two electrons. The less common isotope Helium-3 has two protons and one neutron.

³He

Helium 3 is a rare isotope of the element Helium, consisting of a nucleus with two protons and one neutron. The approved abbreviation (for physics use) for Helium-3 is ³He, however, the abbreviation He3 is also seen. Since most of the Earth's helium is produced by alpha-decay of Uranium isotopes, resulting in ⁴He (the most common isotope of Helium), ³He is rare on Earth. It is comparatively more abundant in non-terrestrial sources, although even in non-terrestrial sources, only a small fraction of helium atoms are Helium 3. The Moon is a source of ³He, which is implanted into the lunar regolith by the solar wind. Helium is present in the soil in quantities of ten to a hundred (weight) parts per million, and 0.003 to 1 percent of this amount (depending on soil) is ³He.

Helium 3 as a Fusion Reaction Fuel

It has been proposed that ³He might be a possible fuel for a Nuclear Fusion reactor to produce energy using the nuclear reaction:

²D + ³He --> ⁴He + ¹H

This reaction has the advantage over the more-commonly proposed D-T fusion reaction that the reaction produces only charged particles (an alpha particle and a proton), with no production of neutrons. However, the corresponding difficulty is that the D-³He reaction has an ignition barrier that is twice as high as the barrier to igniting D-T fusion, because of the fact that the Helium nucleus has twice the charge of a Tritium nucleus. Gerald Kulcinski's group at the Fusion Technology Institute of the University of Wisconsin-Madison has operated an experimental He3 fusion reactor for an extended period, on a non-governmental research budget , however the reactor has not achieved energy balance or breakeven. So far, D-³He fusion has not yet demonstrated net energy production ("break even"). The development of commercial He3 reactors is dependent upon demonstrating "break even."

Value of Lunar Helium 3 in Today's Market

Since He3 has a high market value today, it might be worth collecting He3 from the Moon today simply to sell into the existing terrestrial market. Current market price for He3 is about $46,500 per troy ounce ($1500/gram, $1.5M/kg), more than 120 times the value per unit weight of Gold and over eight times the value of Rhodium.

Questions:

• Can the cost of recovering He3 from the lunar surface reduce that level, e.g. $1500 per gram?
• What would be the capital cost of setting up a small He3 production facility on Luna?
• Would it depress the market price today? This depends on the size of the market, and there is little data.

The US Tritium and helium-3 stockpile sizes are classified, because they give a hint as to how many US nuclear weapons are still functional. According to Wikipedia “approximately 150 kilograms of it (He3) have resulted from decay of US Tritium production since 1955.” One could assume a similar quantity has been accumulated in the ex-USSR, and perhaps additionally from other thermonuclear powers (UK, France, China).

Today, the world's supply of Helium-3 can be counted in hundreds of kilograms, and the value of 100 kg would be $150M. So it may be assumed that the total stockpile value today is roughly about half a billion USD. The US DOE does sell He3 commercially, but how much of the present stockpile has actually been sold on the open market is an open question. Assuming that someone were to start at the level of collecting 100kg of He3 from the Moon and assume its value would be $150M, the cost of soft landing even a small probe on to the lunar surface may easily cost that much or more. How much He3 a small lander manufacture and how many grams per day have yetyet to be determined and production will rely on the method of processing.

The Following Content is currently being formatted. This marker will move down as formatting progresses - Jarogers2001 16:21, 6 August 2008 (UTC)

A commonly discussed method is cooking the regolith to about 1400 degrees Fahrenheit or 760 degrees Celsius. This would need a large amount of energy, requiring the lander to have either a nuclear source (either Nuclear Fission or RTG), or large solar panels. Basalt has specific heat capacity of 0.24 cal/g/degreeC or 0.84 KJ/kg degreeK. To heat 1kg of basalt by 700 degrees Celsius requires about 600 KJ. The highest concentration of He3 in the Maria regions is 0.01ppm in the regolith. This means that 600 KJ will yield 0.01 milligrams of He3. Using these numbers, a 600 Watt power source could produce 0.01 milligrams of He3 per second = 0.6 mg/minute = 36mg/hour = 864mg/day = 315 grams per year. Whether this business concept is viable depends on how quickly a group or entity wants to amortize their investment. If an arbitrary target is to produce 100 kg He3 in one year, then a power source of about 200 KW would be needed. That would give a revenue stream of $150M per year IF the He3 market does not become flooded and the price drops.

How much would it cost to set up a 200KW power source on the Moon?

A Solar Power based system would be in darkness 50% of the time, so would need to operate at 400 KW. If it were on a lunar polar mountain top it might be in near continuous illumination. Let us assume that best case of 100% lighting.

Assuming PV 10% efficiency and a fully steerable array, this would need an area of about 2,000 square meters, or about 45 metres square.

A simple non-PV solar reflector could be near 100% efficient, needing only 200 sq-m or 14 metres square, or aperture.

Setting up a 14 m aperture mirror on the Moon would be a major engineering challenge, although fortunately would not need to be particularly accurate, certainly nothing like as difficult as an astronomical telescope mirror.

How much would it weigh?

Would a Nuclear Fission power plant have better performance per kilogram of lander payload?

Maybe other contributors are interested to develop these lines of thinking.

More thermal analysis needs to be done. For example, might it be possible to recycle the heat using some form of cogeneration. Such as use the hot waste regolith, after it has been processed, to pre-heat the next incoming batch of raw dust, and thus reduce the number of solar joules needed?

That could greatly reduce the size of solar array needed and/or significantly increase the system mass throughput.

Extraction

Baked Regolith

A commonly discussed method is cooking the Regolith to about 1400 degF or 760 deg C. They describe three steps: 1) heat to a few hundred deg C to drive off the volatiles 2) fractional distillation to decant off the heavy volatiles 3) separate He3 from the He4 using standard superleak process Two challenges are devising a method to process large quantities of regolith as the He3 is at a low concentration, and providing a high power thermally efficient heat source on the Moon. This would require a lot of energy, requiring the lander to have either a nuclear source, or large solar panels. Basalt has specific heat capacity of 0.24 cal/g/degC or 0.84 KJ/kg degK. To heat 1kg of basalt by 700degC requires about 600 KJ Best lunar regolith (Maria) might be 0.01 ppm of He3 So the 600 KJ will yield 0.01 milligrams of He3 So 600 Watts power source could produce 0.01 mg He3 per second = 0.6 mg/minute = 36mg/hour = 864mg/day = 315 grams per year

Applications

• Medical Lung Imaging

According to Wikipedia:

http://en.wikipedia.org/wiki/Helium_3

Details on this experimental application of He3: http://cerncourier.com/main/article/41/8/14

Links

• Value of commodities (including He3)

External Links

• Nuclear data

References

Work on this article has outpaced copyediting on it. You can help Lunarpedia by formatting, editing, or tidying it.