Robots in Space Suits

From Lunarpedia
Revision as of 16:43, 22 February 2010 by Farred (talk | contribs) (spelling)
Jump to: navigation, search
  • The lack of long endurance lubricants in vacuum could be worked around by robots wearing space suits. While usually the spacesuit is made to fit the person, with robots the possibility arises that robots could be made to fit spacesuits. So let it be plain, what is meant is not a man shaped robot wearing a man's suit, but a robots in spacesuits with six or more legs each and as many arms as required. Perhaps 0.3 psi pressure would do for robots. At least a gas tight covering of knee or elbow joints could be done with a bellows that has flanges pressed to points above and below the joint by threaded rings. Electrical power wire, control wire, and thermal management fluid hoses could run in a bundle outside of the bellows and have connectors for wires and hoses that would run around the bellows to the pressurized space around the joint . That way the wires and hoses could be disconnected, the bellows unfastened, and the joint unpinned for maintenance, including bellows replacement.
  • The astute reader will realize that this sort of joint covering will not work with rotary bearings of wheels rolling over the ground. So robots could walk and wheeled vehicles could have magnetic bearings. Such vehicles would not be suitable for bouncing over rough terrain, but might give high speed performance over smooth Roads. Wheeled vehicles might work with ordinary greased bearings and frequent lube jobs, or the lubricant rquirement might be solved by special grease and thermal management. The rotary bearing would be within the body of the robot ( as described in the Dust section of Long Endurance Rovers ) where thermal management could be effective.
  • A completely enclosed set of bearings and directional antenna could constantly communicate with a ground station from a rotating space station. A few layers of stuff transparent to the frequency used sandwhiched with three inch layers of vacuum could protect the gas retaining envelope from micrometeoroids. This sort of radome would need too be assembled in orbit since it would be to large to fit in a payload faring.
  • An arm with multiple gas enveloped joints along its length could point a telescope in arbitrary directions. Panning through a 360 degree sweep would cause the image to roll 360 degrees unless there were a rotary bearing for roll control at the telescope end of the arm. A gas tight envelope for a roll control bearing could be maintained if part of the envelope were optical quality glass through which the telescope could see its target. If an ordinary short life rotary bearing is used, loss of roll control would be tollerated when the bearing failed.
  • A bellows can hold a gas envelope around a hydraulic piston too, with some limitations in the structural shape and range of rotation of the bearings at each end of the piston. Slides attached to the inside corners of the bellows folds could move along the cylindar maintaining the propper spacing. These slides would be nestable to not take up too much space along the cylindar when the piston is contracted, and yet not be flat like a washer to avoid binding.